Your shopping cart is empty!
Categories
-
Individual Repair Parts by Model Number
- - American Changer Parts by Model
- - AMS Automated Merchandising Systems Parts by Model
- - Antares or Planet Antares Parts by Model
- - Antique or Old Parts by Model
- - AP Automatic Products Parts by Model
- - Cavalier Parts by Model
- - Centramark Parts by Model
- - CoinCo Parts by Model
- - Coke or Coca Cola Parts by Model
- - Cold Drink Parts by Model
- - Conlux Parts by Model
- - Crane Parts by Model
- - Destiny Solutions Group Parts by Model
- - Dixie Narco Parts by Model
- - Dr. Pepper Parts by Model
- - Edina Parts by Model
- - Genesis Parts by Model
- - GPL Crane Parts by Model
- - LektroVend Parts by Model
- - Maka Parts by Model
- - Mars Parts by Model
- - Mechanical Vending Machine Parts by Model
- - MEI Parts by Model
- - Mixed / Minor Brands
- - National Parts by Model
- - Pepsi Parts by Model
- - PolyVend Parts by Model
- - Purco Parts by Model
- - Rock Ola Parts by Model
- - Rowe Parts by Model
- - Royal Parts by Model
- - Sanden Vendo Parts by Model
- - Seaga Parts by Model
- - Selectivend Parts by Model
- - Snack King Parts by Model
- - USI Parts by Model
- - Vendo Parts by Model
- - Vendolator Parts by Model
- - Vess Cola Parts by Model
- Entire Vending Machines
- Labels Cards Stickers
- How Too!
- Other Categories
VENDO Selection button 1 58" x 3 34" Magnum
Price: $4.25
This is the Clear Plastic Push Button that holds the Magnum Size Flavor Label ( DLAA1175 ) in most of the older single price and some multi prie Vendo Soda machines.
These get replaced from the back, inside of the door.
You will need to loosen or remove both the White Leaf Spring ( DLAA1252 ) and the Black Leaf Spring ( DLAA1143 ).
The Neon sold out lights ( DLAA1049 ) snap or slide out of the clips they are in, most people replace them while they are doing the work of changing the buttons.
The Eletric Switch or Selection Switch itself ( DLAA1135 ) is slid onto a pair of plastic spike or studs, then held in place by the clip which restrains the power cord plugged into the bottom of the Switch. If you are careful and talented you can usually tilt the Clear Plastic Push button enougth to change it out without removing these switchs. If you would rather remove them so they are not in the way, a flat bladed screw driver is very useful for unplugging the cords so the switch can be swung down and then lifted off the studs. Again most people that put the effort into removeing these switchs replace them if they are more than a couple years old. USE CAUTION THESE SWITCHES RUN ON STANDARD 110volt AC Power UNPLUG THE MACHINE BEFORE WORKING ON IT.
When you plug the wires back onto the switches make certain that all three of the metal contacts go down into the plug, or else the machine may not work at all.
Write a review
Your Name:Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below: